1.02g/ml Density Air Filter Adhesive Polyurethane Based Hot Melting

The Raw Material PU Glue Used In The PU Mold Of The Air Filter Accessories Is Used Air Filter Adhesive

1. Product introduction

Two-component polyurethane adhesive for machine

component proportion ratio is 100:25

2. Parameter table

3. Product principle

1.The material must be full rocked after each to the plastic injection machine plastic injection so that the A material mixing evenly.

1.Everytime the plastic injection machine plastic injection A material must be full before the shaking in order to the material until

2.AB material proportioning ratio of A:B=100:25 or 4:1.28°C,you can start operation

3.Material temperature controlled 24°C-28°C appropriate then you can start operation.

4. Must be clean before using the mould release agent (Note:

The new plastic mould can be wiped free)

5 .If A and B is not reaction please measuring A and B ratio.

6. A and B must be sealed to .To avoid the air and water vapor reaction, as a result affecting the effect of colloidal

4. Product use

Because PU rubber has very good comprehensive properties, its application fields are also very wide, almost covering all aspects of industry, agriculture, medical treatment, national defense, etc.; in mining, metallurgy and other aspects, such as: sieve plates, shakers, etc. Mechanical applications such as: seals, plastic bags, rubber rollers, etc.; applications in the construction industry, such as waterproof materials, paving materials, potting materials, etc

                            PU Filter Mould PU filter element mold cabin filter hot melt glue Filter end cap