Washable Hepa Filter Material Air Filter Cover Mould AF25436

Rectangular Square PU Mold For Filter End Cap Manufacturing

1. Product introduction

 Air filter is widely used in many kinds of automobile and engineering equipment. In order to work smoothly, all machines need to replace the filter.

To make the filter, Pu mold is inevitable. High quality Pu mold can be reused up to 80 times, greatly reducing the cost of the filter. Pu mold is made of plastic PP material. Our company purchases high-quality raw materials to meet the quality requirements of customers at home and abroad.

2. Parameter table

  Here are some specifications of the mold for your reference. If you need other shapes, we can customize them.

3. Product characteristics

PP material is round, square and rectangular. It is suitable for PU material air filtration

4. Method of operation

1. Before using glue every day, mix material a evenly with electric hand drill, and shake material B.

2. Turn on the electric heating plate and adjust the temperature to 40-50 ℃. In winter, preheat a and B materials in small containers.

3. Wipe the mold with mold release agent.

4. Mix a and B materials in the ratio of 100:40, then add 40% talc powder, and use 2800 RPM motor to stir the mixed glue solution. The stirring time is determined by the amount of glue, about 7-10 seconds per 100 grams of glue.

5 . Do’s and don’ts

1. This product is generally stored in a dry room, and pay attention to waterproof, moisture, sun protection.

The inner plug and outer cover must be well covered to avoid the rubber absorbing moisture in the air and affecting the use effect.

2. A / b material can be used normally at room temperature (25 ℃), if the temperature is too high or too low, it will affect the use effect.

Manual cooling or heating must be used.

3. The mold must be coated with release agent before pouring, and the mold can be poured only after it is dry.